Renegade Public Forums
C&C: Renegade --> Dying since 2003™, resurrected in 2024!
Home » Renegade Discussions » Mod Forum » Selecting edges
Selecting edges [message #100829] Sat, 10 July 2004 20:04 Go to previous message
flyingfox is currently offline  flyingfox
Messages: 1612
Registered: February 2003
Location: scotland, uk
Karma:
General (1 Star)
This may seem like a stupid question but how do you select the outer lines on editable meshes? :oops:

I'm trying to follow somerhino's terrain tutorial, http://renhelp.co.uk/?tut=8, and it says once the edges on a plane have been moved out and rounded to form base ground, you select the outer edges and set the extrude to 0.00000001. Well, it won't let allow the extrude to go lower than 0.0 and I think the problem is not selecting the edges before that is done.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Mod problem.
Next Topic: Renegade: A New Hope Update
Goto Forum:
  


Current Time: Fri Nov 01 12:23:35 MST 2024

Total time taken to generate the page: 0.00656 seconds