Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » making water question

Show: Today's Messages :: Polls :: Message Navigator

making water question [message #9986]

Thu, 27 March 2003 12:36

Deafwasp
Messages: 555
Registered: February 2003

Karma:

Colonel

I assume you want to make a plane and make it look like moving water. Simple. Create a plane, put a water texture on it; then go to pass 1 in the material editor (the thing you get when you press "m" with a mesh selected)
in Stage 0 Mapping, choose Linear Offset. and in the box type "VPerSec=1"
Then hit the assign material to selection button and you should have it.

If you want to make it transparent then adjust the transparency settings in the same editor, but check valpha. and then go into the w3d tools pallete and check the box that says "VAlpha".

You can also rotate the texture on the mesh to change its direction. and if the texture is going the wrong direction change the VPerSec to UPerSec

Report message to a moderator

[Message index]

		making water question By: Titan1x77 on Wed, 26 March 2003 23:14
		making water question By: Captkurt on Thu, 27 March 2003 08:16
		making water question By: Deafwasp on Thu, 27 March 2003 12:36
		making water question By: Titan1x77 on Thu, 27 March 2003 12:49
		making water question By: Cpo64 on Thu, 27 March 2003 13:00
		making water question By: Titan1x77 on Thu, 27 March 2003 14:13
		making water question By: SomeRhino on Thu, 27 March 2003 14:58
		making water question By: Deafwasp on Thu, 27 March 2003 16:09
		making water question By: Titan1x77 on Thu, 27 March 2003 21:09
		making water question By: Deafwasp on Thu, 27 March 2003 22:38
		making water question By: Titan1x77 on Fri, 28 March 2003 14:50

Previous Topic:	How to?
Next Topic:	Abjab W3D Importer...

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Jan 28 01:39:43 MST 2026

Total time taken to generate the page: 0.00770 seconds