Command and Conquer: Renegade Official Forums: Other Products

Home » Tiberian Technologies / Blackhand Studios » Other Products » brenbot

Show: Today's Messages :: Polls :: Message Navigator

brenbot [message #63141]

Thu, 22 January 2004 09:57

Blazer
Messages: 3322
Registered: February 2003
Location: Phoenix, AZ

Karma:

General (3 Stars)
Administrator/General

Instead of clicking on the bot from windows, run a cmd prompt (start, run, cmd.exe) and then cd to the directory where you installed brenbot (cd \brenbot_131), and then run it from there (brenbot). This way the window will not close and you can see the error message. Your config file looks fine to me, so lets see what the error message says.

Report message to a moderator

[Message index]

		brenbot By: Serenity on Thu, 22 January 2004 08:19
		brenbot By: Blazer on Thu, 22 January 2004 09:57
		brenbot By: Serenity on Thu, 22 January 2004 11:11
		brenbot By: Serenity on Thu, 22 January 2004 11:29
		brenbot By: snipesimo on Thu, 22 January 2004 13:14
		brenbot By: Serenity on Thu, 22 January 2004 13:17
		brenbot By: Serenity on Thu, 22 January 2004 13:41
		brenbot By: Alkaline on Thu, 22 January 2004 14:27
		brenbot By: zunnie on Thu, 22 January 2004 15:01
		brenbot By: Serenity on Thu, 22 January 2004 18:57
		brenbot By: zunnie on Wed, 07 April 2004 01:47
		brenbot By: mac on Wed, 07 April 2004 02:42
		brenbot By: snipesimo on Wed, 07 April 2004 08:55
		brenbot By: Serenity on Wed, 07 April 2004 17:09
		brenbot By: zunnie on Sat, 24 April 2004 19:48
		brenbot By: xptek_disabled on Sat, 24 April 2004 20:30

Previous Topic:	!nextmap error suddenly
Next Topic:	adding commands

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Mar 27 17:30:18 MST 2026

Total time taken to generate the page: 0.00993 seconds