Renegade Public Forums
C&C: Renegade --> Dying since 2003™, resurrected in 2024!
Home » General Discussions » General Discussion » Command & Conquer pins
Re: Command & Conquer pins [message #471645 is a reply to message #471641] Fri, 13 July 2012 16:58 Go to previous messageGo to previous message
Aircraftkiller is currently offline  Aircraftkiller
Messages: 8213
Registered: February 2003
Karma:
General (5 Stars)
http://www.thepinpeople.com/lapelpinpricing/

It looks like the 3/4th of an inch to one inch pins are our best bet for price.

/I sent off for a quote on the GDI pin. I'll find out what the Nod pin will cost. Should be roughly the same, if not identical.
//We'd need to raise about $275 per logo, unless I can get them to make two sets of 50 for the $275 it would cost to make 100 of one pin.

[Updated on: Fri, 13 July 2012 17:11]

Report message to a moderator

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Oldies
Next Topic: Question about video rendering
Goto Forum:
  


Current Time: Sat Dec 21 22:15:32 MST 2024

Total time taken to generate the page: 0.01297 seconds