Command and Conquer: Renegade Official Forums: Other Products

Fri, 05 November 2010 11:15

danpaul88
Messages: 5795
Registered: June 2004
Location: England

Karma:

General (5 Stars)

BRenBot does not use pinfo because it is not supported in all versions of scripts.dll and therefore would not work on 1.037 FDS installations.

		Brenbot Code Questions By: Gen_Blacky on Thu, 04 November 2010 14:11
		Re: Update pinfo By: danpaul88 on Thu, 04 November 2010 15:46
		Re: Update pinfo By: Gen_Blacky on Thu, 04 November 2010 23:02
		Re: Update pinfo By: danpaul88 on Fri, 05 November 2010 02:19
		Re: Update pinfo By: Gen_Blacky on Fri, 05 November 2010 10:55
		Re: Update pinfo By: danpaul88 on Fri, 05 November 2010 11:15
		Re: Update pinfo By: Gen_Blacky on Thu, 02 December 2010 12:51
		Re: Brenbot Code Questions By: danpaul88 on Thu, 02 December 2010 14:39
		Re: Brenbot Code Questions By: Gen_Blacky on Thu, 02 December 2010 16:34
		Re: Brenbot Code Questions By: danpaul88 on Fri, 03 December 2010 01:59
		Re: Brenbot Code Questions By: Ethenal on Fri, 03 December 2010 15:27
		Re: Brenbot Code Questions By: Gen_Blacky on Fri, 03 December 2010 16:07
		Re: Brenbot Code Questions By: Ethenal on Sat, 04 December 2010 08:04
		Re: Brenbot Code Questions By: Hex on Sat, 04 December 2010 08:27
		Re: Brenbot Code Questions By: Gen_Blacky on Fri, 03 December 2010 12:08

Previous Topic:	scripts.dll 3.4.4 is out
Next Topic:	BRenBot serial plugin

Goto Forum:

] [

]

Current Time: Sat May 09 04:13:51 MST 2026

Total time taken to generate the page: 0.00901 seconds