Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Cutting Terrain with boolean

Show: Today's Messages :: Polls :: Message Navigator

Re: Cutting Terrain with boolean [message #370339 is a reply to message #370203]

Tue, 03 February 2009 18:23

Gen_Blacky
Messages: 3250
Registered: September 2006

Karma:

General (3 Stars)

I extrude the bottom of the building to cut a hole in the mesh then i just delete the polygons that from the shape of the mesh and you get a perfect outline.

http://s18.postimage.org/jc6qbn4k9/bricks3.png

Report message to a moderator

[Message index]

		Cutting Terrain with boolean By: rrutk on Tue, 03 February 2009 06:43
		Re: Cutting Terrain with boolean By: Titan1x77 on Tue, 03 February 2009 10:29
		Re: Cutting Terrain with boolean By: rrutk on Tue, 03 February 2009 10:45
		Re: Cutting Terrain with boolean By: Altzan on Tue, 03 February 2009 16:16
		Re: Cutting Terrain with boolean By: mrÃ£Ã§Ä·z on Tue, 03 February 2009 16:19
		Re: Cutting Terrain with boolean By: Gen_Blacky on Tue, 03 February 2009 18:23
		Re: Cutting Terrain with boolean By: Omar007 on Wed, 04 February 2009 04:06
		Re: Cutting Terrain with boolean By: rrutk on Wed, 04 February 2009 06:28

Previous Topic:	obelisk ray
Next Topic:	Powerplants

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Feb 05 09:19:16 MST 2026

Total time taken to generate the page: 0.00698 seconds