Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Cutting Terrain with boolean

Show: Today's Messages :: Polls :: Message Navigator

Re: Cutting Terrain with boolean [message #370232 is a reply to message #370203]

Tue, 03 February 2009 10:29

Titan1x77
Messages: 1086
Registered: February 2003

Karma:

General (1 Star)

a simple way is to just cut the poly of the terrain out then line up the building and turn snap to verts on, then snap the verts from the terrain to the buildings.

"But if the gameplay sucks, the looks don't matter at all." - Sir Phoenixx

Report message to a moderator

[Message index]

		Cutting Terrain with boolean By: rrutk on Tue, 03 February 2009 06:43
		Re: Cutting Terrain with boolean By: Titan1x77 on Tue, 03 February 2009 10:29
		Re: Cutting Terrain with boolean By: rrutk on Tue, 03 February 2009 10:45
		Re: Cutting Terrain with boolean By: Altzan on Tue, 03 February 2009 16:16
		Re: Cutting Terrain with boolean By: mrÃ£Ã§Ä·z on Tue, 03 February 2009 16:19
		Re: Cutting Terrain with boolean By: Gen_Blacky on Tue, 03 February 2009 18:23
		Re: Cutting Terrain with boolean By: Omar007 on Wed, 04 February 2009 04:06
		Re: Cutting Terrain with boolean By: rrutk on Wed, 04 February 2009 06:28

Previous Topic:	obelisk ray
Next Topic:	Powerplants

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun May 17 19:33:30 MST 2026

Total time taken to generate the page: 0.00651 seconds