Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » The amazing invisible mesh!

Show: Today's Messages :: Polls :: Message Navigator

The amazing invisible mesh! [message #174418]

Tue, 11 October 2005 20:06

R315r4z0r
Messages: 3837
Registered: March 2005
Location: Earth

Karma:

General (3 Stars)

In a map i have i made 2 tunnals for the harvesters to go into the tib. field, 1 in each base. What i did was take a box and use boolean and cut a hole into each 1. Then i made planes and put them over the bottoms to make a floor. But when i export the map to the commando editor, the 2 tunnals i made are gone except for the foors of the tunnals. Then boxes that i cut into just disapeared like they werent even there.

I checked all the settings, collitions, projectile, and made sure i didnt hide it accidentally. Also the boxes export geometry and export transform (bone)where both checked.

When in the lvl editor, i can walk onto the floors of the tunnals but i can still walk off the sides just like the mesh wasnt even there.

What should i do to get it to show up?

Report message to a moderator

[Message index]

		The amazing invisible mesh! By: R315r4z0r on Tue, 11 October 2005 20:06
		Re: The amazing invisible mesh! By: Spice on Wed, 12 October 2005 02:18
		Re: The amazing invisible mesh! By: R315r4z0r on Wed, 12 October 2005 20:10
		Re: The amazing invisible mesh! By: Spice on Wed, 12 October 2005 23:28
		Re: The amazing invisible mesh! By: Oblivion165 on Thu, 13 October 2005 07:21
		Re: The amazing invisible mesh! By: R315r4z0r on Fri, 14 October 2005 13:48
		Re: The amazing invisible mesh! By: Oblivion165 on Fri, 14 October 2005 14:26

Previous Topic:	Newest Blackhand Studios project
Next Topic:	Seeding my Map Installer - DVD Edition October 05

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed May 20 06:02:55 MST 2026

Total time taken to generate the page: 0.00646 seconds