Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Boolean Method Tunnel Tutorial

Show: Today's Messages :: Polls :: Message Navigator

Boolean Method Tunnel Tutorial [message #15648]

Sat, 19 April 2003 18:41

Leaddog28
Messages: 10
Registered: April 2003

Karma:

Recruit

I have done that. What I am looking for is an easier way to texture the ceiling, walls and floors. Currently the way I am doing that is by detaching the selected polys. But if you have multiple tunnels cut out of the same box, detaching gets a bit more complicated and is very time consuming. I think that tutorial had a different way of being able to isolate the polys I want to texture.

Just trying to teach an old dog new tricks

Report message to a moderator

[Message index]

		Boolean Method Tunnel Tutorial By: Leaddog28 on Sat, 19 April 2003 10:52
		Boolean Method Tunnel Tutorial By: Blazer on Sat, 19 April 2003 11:14
		Boolean Method Tunnel Tutorial By: Leaddog28 on Sat, 19 April 2003 12:07
		Boolean Method Tunnel Tutorial By: Deafwasp on Sat, 19 April 2003 14:50
		Boolean Method Tunnel Tutorial By: Leaddog28 on Sat, 19 April 2003 18:41
		Boolean Method Tunnel Tutorial By: Deafwasp on Sun, 20 April 2003 00:38
		Boolean Method Tunnel Tutorial By: Leaddog28 on Sun, 20 April 2003 06:22
		Boolean Method Tunnel Tutorial By: Sir Phoenixx on Sun, 20 April 2003 12:15

Previous Topic:	.3ds....
Next Topic:	Alpha-Blending texture goes wrong

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 25 06:46:33 MST 2024

Total time taken to generate the page: 0.01326 seconds