Command and Conquer: Renegade Official Forums: General Discussion

Home » General Discussions » General Discussion » Carving a scorpion tail tutorial

Show: Today's Messages :: Polls :: Message Navigator

Carving a scorpion tail tutorial [message #122155]

Thu, 25 November 2004 04:00

JeffLee67
Messages: 155
Registered: February 2003

Karma:

Recruit

Once it is cut I normally use a Dremel with a sanding drum on it to rough out the curves and make it more 3D:

http://www.n00bstories.com/image.fetch.php?id=1250813036

After the roughing out is done, I'll use hand carving chisels to fine tune it and clean up all the areas that the Dremel can't get into.

JLee1967

All your logos are belong to us!

***************************************************
Any connection between your reality and mine is purely coincidental.
***************************************************

http://www.n00bstories.com/stats/renegade_stats.php?player=JLee1967&team=nod

[Updated on: Thu, 25 November 2004 04:07]

Report message to a moderator

[Message index]

		Carving a scorpion tail tutorial By: JeffLee67 on Thu, 25 November 2004 03:57
		Carving a scorpion tail tutorial By: JeffLee67 on Thu, 25 November 2004 03:59
		Carving a scorpion tail tutorial By: JeffLee67 on Thu, 25 November 2004 04:00
		Carving a scorpion tail tutorial By: JeffLee67 on Thu, 25 November 2004 04:01
		Carving a scorpion tail tutorial By: JeffLee67 on Thu, 25 November 2004 04:03
		Carving a scorpion tail tutorial By: JeffLee67 on Thu, 25 November 2004 04:04
		Carving a scorpion tail tutorial By: JeffLee67 on Thu, 25 November 2004 04:05
		Carving a scorpion tail tutorial By: pulverizer on Thu, 25 November 2004 04:10
		Carving a scorpion tail tutorial By: JeffLee67 on Thu, 25 November 2004 04:18
		Carving a scorpion tail tutorial By: pulverizer on Thu, 25 November 2004 04:27
		Carving a scorpion tail tutorial By: JeffLee67 on Thu, 25 November 2004 04:40
		Carving a scorpion tail tutorial By: pulverizer on Thu, 25 November 2004 05:21
		Carving a scorpion tail tutorial By: Xtrm2Matt on Thu, 25 November 2004 08:54
		Carving a scorpion tail tutorial By: drunkill on Fri, 26 November 2004 19:50

Previous Topic:	Logos
Next Topic:	Last app from me here

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Feb 05 04:50:42 MST 2025

Total time taken to generate the page: 0.00724 seconds