Renegade Public Forums
C&C: Renegade --> Dying since 2003™, resurrected in 2024!
Home » Renegade Discussions » Mod Forum » Renegade Alert Mobile Construction Vehicle (MCV)
Renegade Alert Mobile Construction Vehicle (MCV) [message #119147] Sat, 09 October 2004 01:24 Go to previous messageGo to previous message
Cypher [PCNC] is currently offline  Cypher [PCNC]
Messages: 66
Registered: March 2003
Karma:
Recruit
PiMuRho

Each of the posts in your reference picture continue down through the bridge and into the water.

The bridge supports just protrude above the bridge level. You have the protruding portions above the bridge, but with no supports underneath.


ACK, he's right.
These are not just poles, they are the supports portruding on top of the bridge, and the render from the movie actually shows that (two supports, not just one). At the lower left corner of the picture where you clearly see one support, there's also, if you move a bit to the right, a solid object that continues past the brick line - another support right under the next pole.

And since we're already on the subject, it does seem as if the MCV would fit between two poles/supports. Although, granted, it doesn't matter since, as you say, you can put as many as you want there, arbitrarily - as long as you understand that they are not just poles, but supports that go above the bridge as well.


Cypher
@ Planet Command & Conquer
http://www.planetcnc.com
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Westwood ftp down
Next Topic: Question about modeling in Gmax...
Goto Forum:
  


Current Time: Tue Dec 03 22:30:14 MST 2024

Total time taken to generate the page: 0.04606 seconds