Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Not Again....

Show: Today's Messages :: Polls :: Message Navigator

Not Again.... [message #-985413]

Tue, 21 January 2003 02:40

Anonymous

Have you clicked disply in the material editor and then assign material to selection?. Have you applied a texture mapping modifier? Such as UVW map then using vertex paint. Make sure your mesh is not back to front because gmax enables backface cull by default on most things. In this case either flip over your mesh or disable backface cull if your using the mesh as double sided.

Hope this helps

Report message to a moderator

[Message index]

		Not Again.... By: Anonymous on Tue, 21 January 2003 02:25
		Not Again.... By: Anonymous on Tue, 21 January 2003 02:40
		Not Again.... By: Anonymous on Tue, 21 January 2003 07:01
		Not Again.... By: Anonymous on Tue, 21 January 2003 10:26
		Not Again.... By: Anonymous on Tue, 21 January 2003 10:49

Previous Topic:	LevelEdit trying to Run in 640 x 480 !?!
Next Topic:	flying scripts

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue May 12 15:35:41 MST 2026

Total time taken to generate the page: 0.00632 seconds