Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » easy RENX question

Show: Today's Messages :: Polls :: Message Navigator

easy RENX question [message #7382]

Tue, 18 March 2003 08:13

Titan1x77
Messages: 1086
Registered: February 2003

Karma: 0

General (1 Star)

if i create a box and make a tunnel out of it how do i make the box thicker ...so it's not so thin?

"But if the gameplay sucks, the looks don't matter at all." - Sir Phoenixx

Report message to a moderator

easy RENX question [message #7404]

Tue, 18 March 2003 10:16

Deafwasp
Messages: 555
Registered: February 2003

Karma: 0

Colonel

you mean to make the tunnel wider? or make the tunnel walls thicker?

Look, this is how i make simple tunnels:

Use the tool to make a tube, make sure the number of sides is set to 4. Then put in the number hieght segments you want in it (for angles in the tunnel).

Then make the tube. select and delete the outside polygons as you wont see them if its a underground tunnel.

You should have no problems with tunnels if you use this method. And you know how to edit meshes.

Remember to new mappers: select your mesh, right click on it, and make editable mesh.
Then select the button that looks like three little dots in the pallete to the right. The dots are verticies, ou select them and move them in the X,Y and Z dimensions. That is how you model meshes.

Report message to a moderator

easy RENX question [message #7840]

Wed, 19 March 2003 14:11

Captkurt
Messages: 488
Registered: February 2003

Karma: 0

Commander

To learn how to use the Boolean tool check out my tutourial you can get it at http://www.nodnl.net/ it's called "Using the Boolean tool"

Report message to a moderator

Previous Topic:	2SIDE in W3D options
Next Topic:	Can i place a building controller on a MCT only (no building

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 14 17:05:48 MST 2025

Total time taken to generate the page: 0.00610 seconds