Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » renx unwrap help

Show: Today's Messages :: Polls :: Message Navigator

renx unwrap help [message #447989]

Wed, 25 May 2011 21:05

NACHO-ARG
Messages: 397
Registered: October 2010

Karma: 0

Commander

i am workin in a model, it uses 2 tga textures for diferents part of the mesh but it is only 1 object, how can i unwrap it? so each texture whould dislay in his fase/poligon whitout afecting the wole object. any ideas?

Report message to a moderator

Re: renx unwrap help [message #448108 is a reply to message #447989]

Fri, 27 May 2011 18:21

Gen_Blacky
Messages: 3250
Registered: September 2006

Karma: 1

General (3 Stars)

unwrapping is hard and takes a lot of time just do this

http://www.youtube.com/watch?v=tyd_fObPg8Q

http://s18.postimage.org/jc6qbn4k9/bricks3.png

Report message to a moderator

Re: renx unwrap help [message #448112 is a reply to message #448108]

Fri, 27 May 2011 18:42

wubwub
Messages: 142
Registered: May 2009
Location: Ontario

Karma: 0

Recruit

To the extent of my knowledge,

You can't unwrap in RenX, you need 3DS max or something else with the capability to unwrap.

(when i attempted it in RenX, I never saw the UNWRAP UVW modifier, only reason Im saying this)

When renegade goes Wub, it never goes back

(or at least until I re-install renegade anyways)

http://i266.photobucket.com/albums/ii272/ZaydenX/Walrus-Sig.jpg

[Updated on: Fri, 27 May 2011 18:44]

Report message to a moderator

Re: renx unwrap help [message #448114 is a reply to message #447989]

Fri, 27 May 2011 19:08

Gen_Blacky
Messages: 3250
Registered: September 2006

Karma: 1

General (3 Stars)

Attachment: unwrap.jpg
(Size: 71.05KB, Downloaded 255 times)

Report message to a moderator

Re: renx unwrap help [message #448115 is a reply to message #448114]

Fri, 27 May 2011 19:44

wubwub
Messages: 142
Registered: May 2009
Location: Ontario

Karma: 0

Recruit

Pfft.

I stand corrected Tell Me

When renegade goes Wub, it never goes back

(or at least until I re-install renegade anyways)

[Updated on: Fri, 27 May 2011 19:44]

Report message to a moderator

Re: renx unwrap help [message #448118 is a reply to message #447989]

Fri, 27 May 2011 22:34

NACHO-ARG
Messages: 397
Registered: October 2010

Karma: 0

Commander

thanks for the help guys, i figure it out, i just cut the model in peses and renamed so i have diferent object and can now aply the diferents tga to each object, i had became very practical in renx uwnrap if someone need help whit this plese just ask Smile