Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Extraction from always.dat

Show: Today's Messages :: Polls :: Message Navigator

Extraction from always.dat [message #404160]

Sun, 27 September 2009 17:54

raven
Messages: 595
Registered: January 2007
Location: Toronto, Ontario

Karma: 0

Colonel

Is there any way to mass-extract files from always.dat instead of 1 by 1?

-Jelly Administrator
-Exodus Administrator

Report message to a moderator

Re: Extraction from always.dat [message #404163 is a reply to message #404160]

Sun, 27 September 2009 18:04

Altzan
Messages: 1586
Registered: September 2008
Location: Tennessee

Karma: 0

General (1 Star)

raven wrote on Sun, 27 September 2009 17:54

Is there any way to mass-extract files from always.dat instead of 1 by 1?

I use RenegadeEx to extract files from always.dat, an it can extract many at once.

I cannot imagine how the clockwork of the universe can exist without a clockmaker. ~Voltaire

Report message to a moderator

Re: Extraction from always.dat [message #404166 is a reply to message #404160]

Sun, 27 September 2009 18:22

raven
Messages: 595
Registered: January 2007
Location: Toronto, Ontario

Karma: 0

Colonel

Ah.. I've been using XCC mixer lol

I'll give that a try, thanks Smile

-Jelly Administrator
-Exodus Administrator

Report message to a moderator

Re: Extraction from always.dat [message #404172 is a reply to message #404166]

Sun, 27 September 2009 19:45

saberhawk
Messages: 1068
Registered: January 2006
Location: ::1

Karma: 0

General (1 Star)

raven wrote on Sun, 27 September 2009 21:22

Ah.. I've been using XCC mixer lol

I'll give that a try, thanks Smile

Mixer has 3 columns. Pull out the middle one and navigate to where you want the files extracted to. Then navigate to always.dat or whatever and select all the files and then choose "Copy" and it'll extract them all into where you have the middle column located.

Report message to a moderator

Re: Extraction from always.dat [message #404206 is a reply to message #404172]

Sun, 27 September 2009 23:36

Spyder
Messages: 1070
Registered: March 2006

Karma: 0

General (1 Star)

Saberhawk wrote on Mon, 28 September 2009 04:45

raven wrote on Sun, 27 September 2009 21:22

Ah.. I've been using XCC mixer lol

I'll give that a try, thanks Smile

True, but one small note. It might look like XCC Mixer stops working, but if you wait a short while it will start responding again, and you'll see that all files have been copied.

Report message to a moderator