Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Vehicle camera editing

Show: Today's Messages :: Polls :: Message Navigator

Vehicle camera editing [message #295728]

Fri, 09 November 2007 08:02

r34ch
Messages: 8
Registered: November 2007

Karma: 0

Recruit

Ok bare with me here, i've not done any modding for renegade apart from some mapping in renX.

Basically i want to edit a vehicle camera position so that in game the camera is higher than it currently is when driving it.

Also i want to change how the angle of the barrel reacts to the mouse movements, so instead of the barrel aiming straight where i point the cross-hairs, it aims at an greater angle so when you fire it fires above the target.

Any feedback at all is much appreciated

[Updated on: Fri, 09 November 2007 08:07]

Report message to a moderator

Re: Vehicle camera editing [message #295757 is a reply to message #295728]

Fri, 09 November 2007 09:46

mrÃ£Ã§Ä·z
Messages: 3069
Registered: August 2007

Karma: 0

General (3 Stars)
Permabanned for trying and failing DDoS

theres a "Camera.ini" there you can change it very easy Very Happy

i think it was in "Always.Dat", you need to open it with XCC mixer. Then copy the edited cameras.ini in youre renegade/data folder. But online it dont work, serverlist wont load.

Report message to a moderator

Re: Vehicle camera editing [message #295783 is a reply to message #295757]

Fri, 09 November 2007 12:46

Gen_Blacky
Messages: 3250
Registered: September 2006

Karma: 1

General (3 Stars)

MadRockz wrote on Fri, 09 November 2007 10:46

theres a "Camera.ini" there you can change it very easy Very Happy

i think it was in "Always.Dat", you need to open it with XCC mixer. Then copy the edited cameras.ini in youre renegade/data folder. But online it dont work, serverlist wont load.

if its in a pkg it will