| Selecting edges [message #100829] |
Sat, 10 July 2004 20:04  |
flyingfox
Messages: 1612
Registered: February 2003
Location: scotland, uk
Karma: 0
|
General (1 Star) |
|
|
This may seem like a stupid question but how do you select the outer lines on editable meshes? :oops:
I'm trying to follow somerhino's terrain tutorial, http://renhelp.co.uk/?tut=8, and it says once the edges on a plane have been moved out and rounded to form base ground, you select the outer edges and set the extrude to 0.00000001. Well, it won't let allow the extrude to go lower than 0.0 and I think the problem is not selecting the edges before that is done.
|
|
|
|
| Selecting edges [message #100834] |
Sat, 10 July 2004 20:46  |
 |
SuperFlyingEngi
Messages: 1756
Registered: November 2003
Karma: 0
|
General (1 Star) |
|
|
Hm...is that an older version of gmax or something? The current interface I have doesn't look exactly like that one....
Anyway, 0.00000001 is higher than 0.0.
Good luck with the tutorial.
"To announce that there must be no criticism of the President, or that we are to stand by the President, right or wrong, is not only unpatriotic and servile, but is morally treasonable to the American public." -- Theodore Roosevelt (1918)
"The danger to political dissent is acute where the Government attempts to act under so vague a concept as the power to protect "domestic security." Given the difficulty of defining the domestic security interest, the danger of abuse in acting to protect that interest becomes apparent. --U.S. Supreme Court decision (407 U.S. 297 (1972)
The Liberal Media At Work
An objective look at media partisanship
|
|
|
|
|
|
| Selecting edges [message #100843] |
Sat, 10 July 2004 22:39 |
 |
Spice
Messages: 1448
Registered: November 2003
Location: Ohio
Karma: 0
|
General (1 Star) |
|
|
Hmm dont forget , Hold Ctrl for multiple selection. Alt for Multiple De-Selection.
|
|
|
|
| Selecting edges [message #100849] |
Sat, 10 July 2004 23:07 |
flyingfox
Messages: 1612
Registered: February 2003
Location: scotland, uk
Karma: 0
|
General (1 Star) |
|
|
|
Thanks for all the help, 2 should do it.
|
|
|
|
| Selecting edges [message #100861] |
Sun, 11 July 2004 01:20 |
 |
Dan
Messages: 395
Registered: August 2003
Location: UK
Karma: 0
|
Commander |
|
|
|
When you write 0.0000001 in the extrude box then click on extrude, it does extrude the edge/polygon, but since gmax does go any more precise than to 3 decimal places, it doesnt move, but is still extruded. So after you have extruded them, just move them to where you want, and it should extrude properly.
|
|
|
|
Search
Help
Members
Register
Login
Home
