Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Gmax line-3d question

Show: Today's Messages :: Polls :: Message Navigator

Gmax line-3d question [message #-994022]

Mon, 14 October 2002 17:24

Anonymous

Ok let me try to make this more understandable. I know I'm confusing sometimes. [Frown]

Lets say I draw a octagon with the line tool. When I finish drawing my line, and bringing it back around to where I started gmax/renx asks me if I want to close the line, and I do. After that I select the face of the flat object I have just drawn with the line tool, then I right click and convert it to editable mesh. After that I go to the extrude feild, and choose how much I want to extrude it. Heres the problem when I flip the object around after extruding there is no poly covering the other side which I understand since it is basicly a plane but is there a way to close off the other end? ? ? Hope that made sense I sure know it went right over my head [Razz]

Report message to a moderator

[Message index]

		Gmax line-3d question By: Anonymous on Mon, 14 October 2002 00:08
		Gmax line-3d question By: Anonymous on Mon, 14 October 2002 02:08
		Gmax line-3d question By: Anonymous on Mon, 14 October 2002 02:38
		Gmax line-3d question By: Anonymous on Mon, 14 October 2002 17:06
		Gmax line-3d question By: Anonymous on Mon, 14 October 2002 17:24
		Gmax line-3d question By: Anonymous on Mon, 14 October 2002 17:49
		Gmax line-3d question By: Anonymous on Mon, 14 October 2002 09:49
		Gmax line-3d question By: Anonymous on Mon, 14 October 2002 11:57
		Gmax line-3d question By: Anonymous on Mon, 14 October 2002 18:34

Previous Topic:	Respect for fan map makers !
Next Topic:	New structues and beacons

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Feb 01 22:03:33 MST 2025

Total time taken to generate the page: 0.01441 seconds